Gestetner CP6244 Operating Instructions Manual page 260

Appendix
Network Interface Board configuration settings information
Use the show command to display the Network Interface Board configuration
settings.
msh> snmp [-p]
Note
Add "-p" to the show command to have the information displayed one screen
at a time.
Reference
For more information about the meaning of the data returned with this com-
mand, see p.104 "Configuring the Network Interface Board".
System log information
Use the syslog command to display information stored in the machine's system
log.
msh> syslog
Reference
For more information about the displayed information, see p.107 "System
Log Information".
7
SNMP
Use the snmp command to display and edit SNMP configuration settings such
as the community name.
Note
You can configure from ten SNMP access settings numbered 1–10.
Default access settings 1 and 2 are as follows.
Number
Community name
IP address
Access type
Display
Shows the SNMP information and available protocols.
msh> snmp ?
msh> snmp [-p] [registered_number]
Note
If the -p option is added, you can view the settings one by one.
Omitting the number displays all access settings.
96
1 2
public admin
0.0.0.0 0.0.0.0
read-only read-write
trap off trap off