Skip Feed Printing - Gestetner CP6244 Operating Instructions Manual

Operation

Skip Feed Printing

If the backs of prints are dirty, you
can use the {Skip Feed} key to make
1
the drum rotate twice instead of once
with every sheet of paper fed. This
gives you time to remove prints one
by one from the paper delivery tray,
or to insert a sheet of paper between
two prints.
Note
❒ You can specify how many times
that the drum rotates when the
power is turned on. Alternatively,
you can also choose whether or not
to change the number of rotations
temporarily when the {Skip Feed}
key is pressed. See "8 No. of Skip
Feed" on p.79 "4 Mode Setting".
❒ The number of rotations can be set
from 2 to 9.
❒ The default is 2.
A
Press the {Skip Feed} key.
B
Set your original.
C
Enter the number of prints with
the number keys.
56
D
Press the {Master Making} key.
Printing starts automatically after
the trial print.
Note
❒ If you wish to check the image
before printing, press the {Auto
Cycle} key before pressing the
{Master Making} key, in order to
disable Auto Cycle mode. See
p.18 "When Auto Cycle mode is
off".
ZLKS085N
AQN024S