Gestetner CP6244 Operating Instructions Manual page 374

Troubleshooting
Messages/Second messages
<Type B only>
"Processing...(Online)"
"Print is not finished (On-
line)"
"Press [finish PRNT] key to
start next mstr makg"
(These messages appear re-
peatedly.)
Processing
4
Ready for Master Mak-
ing/Printing (Online)
Ready for Master Mak-
ing/Printing
Resetting Job...
ROM Error.
<Type A>
Selected paper size is una-
vailable. Press [MakeMstr] to
continue as is, or set ### pa-
per then press [OK].
<Type B>
Selected paper size is una-
vailable. Press [Make Mas-
ter] to continue as is,or set
###### paper, then press
[OK].
Set ###### paper, then press
[OK].
Add paper.
Paper tray is not set. Open
the papre tray.
Waiting...(Online)
34
Descriptions and Solutions
Printing is not finished.
Printing has been interrupted. Perform one of the following
procedures:
• Press the { { { { Print} } } } key, and printing will restart. When the
printing is finished, the display returns to the initial display.
• Press the { { { { OK} } } } key, and then the interrupted printing is can-
celled. If there is the following print job, Master Making for
it starts automatically.
• Press the { { { { Job Reset} } } } key, and printing will stop. The inter-
rupted prints will not be performed. If there is the following
print job, these three messages appear again. If there is no
print job, press the { { { { OK} } } } key to return to the intial display.
Data is being printed.
Wait until the job is finished.
The Master Making or print data is not in the spool.
This is not an error. The message will change when printing
starts from the computer.
The data spooled is dumped.
Wait until the job is finished.
The ROM inside the machine is abnormal.
Consult your sales or service representative.
The specified paper size has not been set.
Set an appropriate amount of paper, and then press [OK].
Note
"###" in the message represents a paper size.
The specified paper size has not been set.
Set an appropriate amount of paper, and then press the { { { { OK} } } }
key.
"###" in the message represents a paper size.
No paper in the Paper Feed Tray.
After setting ### paper in the Paper Feed Tray, press [OK]
(When using Type B, press the { { { { OK} } } } key) to continue.
Note
"###" in the message represents a paper size.
No paper in the Paper Feed Tray, or the Paper Feed Tray is not
set correctly.
Make sure the Paper Feed Tray is set correctly and set an appro-
priate amount of paper. The error message will disappear.
Waiting for data from the computer.
Wait until the job is finished.