Gestetner CP6244 Operating Instructions Manual page 221

Setting Up as a Print Server
A A A A
Log on to the file server as a Supervisor or a Supervisor equivalent.
B B B B
Run the NIB Setup Tool.
Reference
p.52 "Running the NIB Setup Tool"
C C C C
Click [Property Sheet] and click [OK].
The [NIB Setup Tool - Network board list] dialog box of the Network Interface
Board appears.
D D D D
Click [IPX protocol].
E E E E
Click the IPX address of the Network Interface Board which is to be config-
ured, and then click [Next >].
Note
If you do not know which Network Interface Board you are configuring,
see the system configuration list to check the MAC address (Network Ad-
dress).
F F F F
Make sure that the MAC address and IPX address are correct, and click [Fin-
ish].
The [NIB Setup Tool] window appears.
G G G G
Click [Configure].
The property sheet appears.
H H H H
Click the [General] tab, and type the name of the print server into the [Device
Name] box.
I I I I
Click the [NetWare] tab, and make the following settings.
A Select [Bindery].
B In the [File Server Name:] box, type the name of the file server in which a
print server is to be created.
Click [Browse] to select a file server among those listed in the [Browse] dia-
log box.
C Click [OK] to close the property sheet.
D After the confirmation dialog box appears, click [OK].
J J J J
On the [NIB] menu, click [Exit] to exit the NIB Setup Tool.
K K K K
Type "PCONSOLE" from the command prompt.
F:> PCONSOLE
NetWare 3.x - Advanced Settings
5
57