Configuring a Windows 95/98/Me computer
These steps are for configuring a Windows 95/98/Me computer to use the
TCP/IP protocol.
A A A A
Open the [Control Panel] and double-click the [Network] icon. Make sure that
"TCP/IP" is listed in the [The following network components are installed:] box on
the [Configuration] tab.
Note
If the TCP/IP protocol is not installed, click the [Add] on the [Configuration]
tab to install it. For more information about installing the TCP/IP protocol,
see Windows 95/98/Me Help.
B B B B
Configure the TCP/IP protocol with the appropriate IP address, subnet
mask and other settings.
Check with the network administrator that the settings are correct.
Configuring NetBEUI for Printing
These instructions are for configuring the Network Interface Board and Win-
dows 95/98/Me to use the NetBEUI protocol.
Configuring the machine
Configure the machine to use the NetBEUI protocol.
• Make sure that the NetBEUI protocol is set to active. (The default is active.)
Note
The NetBEUI settings are performed in Web Status Monitor or SmartDevice-
Monitor for Admin. See the corresponding online Help for details.
Configuring the Protocols
1
3