Adjusting The Paper Alignment Wings And Chocks - Gestetner CP6244 Operating Instructions Manual

B
Lift the paper delivery side plates
and adjust them to match the pa-
per size.
C
Lift the paper delivery end plate
and adjust it to match the paper
size.
Adjusting the Paper Alignment
Wings and Chocks
Use the paper alignment wings and
chocks to stack printed paper neatly.
Note
❒ Prints may be delivered curled up
if they contain large areas of solid
image. If this happens, raise the
paper alignment wings to about 45
degrees. When printing on B5
JISL K or A4K of 52.3 g/m
ABL024S
lb or thinner, slide the chocks up
together.
❒ Depending on the type of paper
you are using, you may not be able
to load to capacity (1000 sheets)
when the wings are raised.
❒ When printing on 52.3 g/m
lb or thinner at a fast speed, paper
jams (C) may occur in the paper
exit area. If this happens, do the
following:
• Decrease print speed.
Reference
ACY064S
p.27 "Changing the Printing
Speed"
• Lower the paper alignment wings.
• Push the end plate toward the
paper delivery tray edge.
❒ When the paper alignment wings
are raised, prints may not be deliv-
ered neatly stacked, depending on
paper type. If this happens, lower
the wings.
Printing Preparations
2
, 13.9
2
, 13.9
13
1