Appendix
The Network Interface Board is reset automatically when the settings are
changed.
When the Network Interface Board is reset, the active print job which has
already been sent to the machine will finish printing. However, jobs that
have not been sent yet will be canceled.
Commands List
This is a list of commands that can be used via remote maintenance.
Note
Type "help" to see a list of commands that can be used.
msh> help
Type "help command_name" to display information about the syntax of that
command.
msh> help command_name
TCP/IP address
Use the ifconfig command to configure TCP/IP for the machine (IP address, sub-
net mask, broadcast address, default gateway address).
Reference
7
msh> ifconfig
Configuration
msh> ifconfig le0 parameter address
Parameter
(no parameter)
netmask
gateway
The following is an example for configuring an IP address of 192.168.15.16.
msh> ifconfig le0 192.168.15.16
The following is an example for configuring a subnet mask of 255.255.255.0.
msh> ifconfig le0 netmask 255.255.255.0
Note
This affects the configuration of the Network Interface Board of the IP ad-
dress that is used.
To type an address using hexadecimal, prefix it by "0x".
92
Meaning
IP address
subnet mask
default gateway address