Gestetner CP6244 Operating Instructions Manual page 261

Community name configuration
You can set the community name of the Network Interface Board.
msh> snmp number name community_name
Note
The community name must consist of 15 characters or less.
Access type configuration
You can select the access type from those listed below.
msh> snmp number type access_type
Access type Type of access which is permitted
read Read only
write Read and write
trap User is notified of trap messages.
no All access is denied.
Protocol configuration
You should use the following command to set the protocols to active or inac-
tive. If you set a protocol to inactive, all access settings set to use that protocol
are disabled.
msh> snmp {ip | ipx} {on | off}
• "on" means active and "off" means inactive
To change the protocol of an access settings, use the following command.
However, if you disabled a protocol with the above command, making it ac-
tive here will have no effect.
msh> snmp number active {ip | ipx} {on | off}
Access configuration
You can configure the address of a host depending on the protocols used.
The Network Interface Board accepts requests only from hosts having ad-
dresses with access types of "read-only" or "read-write". Type "0" to have the
Network Interface Board accept requests from any host without requiring a
specific type of access.
Command syntax:
msh> snmp number {ip | ipx}address
Note
To specify the TCP/IP protocol, type ip followed by a space and then the
IP address.
To specify the IPX/SPX protocol, type ipx followed by a space and then the
IPX address followed by a decimal and then the MAC address of the Net-
work Interface Board.
Remote Maintenance by telnet (mshell)
7
97