Gestetner CP6244 Operating Instructions Manual page 169

Using SmartDeviceMonitor for Client
SmartDeviceMonitor for Client is a utility for printing with the network printer
using the TCP/IP, NetBEUI, and IPP protocols. The following features are avail-
able when using SmartDeviceMonitor for Client.
SmartDeviceMonitor for Client features
• Sends a print job directly to the network printers without using a print
server.
• Notifies when a printing error occurs.
• That print did completion (data transmission is finished) is informed.
Note
Make sure to close all applications before beginning the installation process.
Installing SmartDeviceMonitor for Client may require the computer to be re-
started.
Installing SmartDeviceMonitor for Client
Follow the procedure below to install SmartDeviceMonitor for Client.
Note
When there is a printing port used by PortNavi, Multi Direct Print and Print-
ing System95, SmartDeviceMonitor for Client will take over.
When using SmartDeviceMonitor for Admin, install SmartDeviceMonitor for
Client after SmartDeviceMonitor for Admin is closed.
Make sure to close all applications before beginning the installation process.
Installing SmartDeviceMonitor for Client may require the computer to be re-
started.
A A A A
Insert the CD-ROM labeled "Printer Drivers and Utilities" into the CD-
ROM drive.
B B B B
Open [Control Panel], and double-click the [Add/Remove Programs] icon.
C C C C
On the [Install/Uninstall] tab, click [Install].
D D D D
Click [Next >].
E E E E
Type the name of the CD-ROM drive in the [Command line for installation pro-
gram] box, followed by ":\ NETWORK \ NETMON \ CLIENT \ DISK1 \
SETUP.EXE" (do not include the quotation marks), and then click [Finish].
Note
An example would be "D:\ NETWORK \ NETMON \ CLIENT \ DISK1
\ SETUP.EXE" when the CD-ROM drive letter is "D".
Using SmartDeviceMonitor for Client
1
5