Gestetner CP6244 Operating Instructions Manual page 264

Appendix
Changing the NetBIOS name
Use the hostname command to change the NetBIOS name of the machine.
msh> hostname NetBIOS name of the machine
Note
The NetBIOS name consists of up to 13 alphanumeric characters.
You cannot use a name starting with "RNP" or "rnp".
WINS
Use the wins command to configure the WINS server.
Reference
For how to configure the WINS server, see p.116 "Configuring a WINS Serv-
er".
WINS configuration
Use the set command to make WINS active or inactive.
msh> set wins {on|off}
• "on" means active and "off" means inactive.
View settings
7
The following command displays the IP addresses of the WINS server.
msh> wins
Example output:
wins: primary server 192.168.10.1 secondary server
192.168.10.2
wins server current config: secondary server 192.168.10.1
secondary server 192.168.10.2 hostname 123456789abcd Sco-
peID
Note
The current configuration appears on the second line when DHCP is ac-
tive. When DHCP is not active, there is no second line.
If the network boot setting is changed to another from DHCP, the WINS
server IP addresses that were saved on the machine may differ from the
current IP addresses.
Address configuration
Specify the WINS server IP addresses.
msh> wins {primary|secondary}IP_address
Use "primary" to specify the primary WINS server IP address, and use "sec-
ondary" to specify the secondary WINS server IP address.
100