Gestetner CP6244 Operating Instructions Manual page 258

Appendix
For example, if you assign 192.168.15.16 as the Access Control Address of the
Network Interface Board, the IP addresses that can print are as follows. XXX
means any number from 1 to 255 is acceptable.
Access Control Mask
0.
255.
255.255.
255.255.255.
255.255.255.255
Configuration for multiple access controls
msh> access multi {on | off}
•"on" means active and "off" means inactive.
msh> access {1 - 5} parameter address
Note
Up to 5 access controls are available. Specify the number (1 - 5) when con-
figuring some access controls. If this is not configured, the first setting is
selected.
7
Network Boot
Use the set command to configure the boot method.
msh> set parameter {on | off}
•"on" means active and "off" means inactive.
Parameter
ping
tftp
bootp
dhcp
Note
When you use RARP+TFTP, BOOTP or DHCP, the server also needs to be
configured.
DHCP takes precedence over all other settings.
94
0. 0. 0
0. 0. 0
0. 0
0
Meaning
ARP+PING
RARP+TFTP
BOOTP
DHCP (Dynamic Host Configuration
Protocol)
IP addresses that can access the
machine
XXX.XXX.XXX.XXX
192.XXX.XXX.XXX
192.168.XXX.XXX
192.168. 15.XXX
192.168. 15. 16