Show Bridge Multicast Address-Table Static - Cisco Sx350 Cli Manual

Address Table Commands
Cisco Sx350 Ph. 2.2.5 Devices - Command Line Interface Reference Guide
4.29 show bridge multicast address-table
static
To display the statically-configured Multicast addresses, use the show bridge
multicast address-table static Privileged EXEC mode command.
Syntax
show bridge multicast address-table static [vlan
show bridge multicast address-table static [vlan
mac-multicast-address
show bridge multicast address-table static [vlan
ipv4-multicast-address
show bridge multicast address-table static [vlan
ipv6-multicast-address
Parameters
•
vlan-id
vlan —(Optional) Specifies the VLAN ID.
•
address—(Optional) Specifies the Multicast address. The possible values
are:
-
mac-multicast-address—(Optional) Specifies the MAC Multicast
address.
-
ipv4-multicast-address—(Optional) Specifies the IPv4 Multicast
address.
-
ipv6-multicast-address—(Optional) Specifies the IPv6 Multicast
address.
•
source—(Optional) Specifies the source address. The possible values are:
-
ipv4-address—(Optional) Specifies the source IPv4 address.
-
ipv6-address—(Optional) Specifies the source IPv6 address.
Default Configuration
When all/mac/ip is not specified, all entries (MAC and IP) will be displayed.
Command Mode
Privileged EXEC mode
] [mac| ip]
ipv4-source-address
] [source
ipv6-source-address
] [source
vlan-id
] [all]
vlan-id
] [address
vlan-id
] [address
]
vlan-id
] [address
]
4
162