Example: Adding The Static Address To The Mac Address Table - Cisco Catalyst 2960 series Configuration Manual

Additional References for Switch Administration

Example: Adding the Static Address to the MAC Address Table

This example shows how to add the static address c2f3.220a.12f4 to the MAC address table. When a packet
is received in VLAN 4 with this MAC address as its destination address, the packet is forwarded to the specified
port:
Switch(config)# mac address-table static c2f3.220a.12f4 vlan 4 interface gigabitethernet1/1/1
Example: Configuring Unicast MAC Address Filtering
This example shows how to enable unicast MAC address filtering and how to configure drop packets that
have a source or destination address of c2f3.220a.12f4. When a packet is received in VLAN 4 with this MAC
address as its source or destination, the packet is dropped:
Switch(config)# mac address-table static c2f3.220a.12f4 vlan 4 drop
Additional References for Switch Administration
Related Documents
Related Topic
Switch administration commands
Network management configuration
Layer 2 configuration
VLAN configuration
Platform-independent command references
Platform-independent configuration
information
Standards and RFCs
Standard/RFC
None
Consolidated Platform Configuration Guide, Cisco IOS Release 15.2(4)E (Catalyst 2960-X Switches)
1556
Document Title
Catalyst 2960-X Switch System Management Command
Reference
Catalyst 2960-X Switch Network Management Configuration
Guide
Catalyst 2960-X Switch Layer 2 Configuration Guide
Catalyst 2960-X Switch VLAN Management Configuration
Guide
Cisco IOS 15.3M&T Command References
Cisco IOS 15.3M&T Configuration Guides
Title
—