Chapter 2
Catalyst 3750-X and 3560-X Switch Cisco IOS Commands
mac address-table static
Syntax Description
Defaults
Command Modes
Command History
Examples
Related Commands
OL-21522-02
Downloaded from
www.Manualslib.com
Use the mac address-table static global configuration command on the switch stack or on a standalone
switch to add static addresses to the MAC address table. Use the no form of this command to remove
static entries from the table.
mac address-table static mac-addr vlan vlan-id interface interface-id
no mac address-table static mac-addr vlan vlan-id [interface interface-id]
mac-addr
vlan vlan-id
interface interface-id
No static addresses are configured.
Global configuration
Release
12.2(53)SE2
This example shows how to add the static address c2f3.220a.12f4 to the MAC address table. When a
packet is received in VLAN 4 with this MAC address as its destination, the packet is forwarded to the
specified interface:
Switch(config)# mac address-table static c2f3.220a.12f4 vlan 4 interface
gigabitethernet6/0/1
You can verify your setting by entering the show mac address-table privileged EXEC command.
Command
show mac address-table static
manuals search engine
Destination MAC address (unicast or multicast) to add to the address
table. Packets with this destination address received in the specified
VLAN are forwarded to the specified interface.
Specify the VLAN for which the packet with the specified MAC address
is received. The range is 1 to 4094.
Interface to which the received packet is forwarded. Valid interfaces
include physical ports and port channels.
Modification
This command was introduced.
Description
Displays static MAC address table entries only.
Catalyst 3750-X and 3560-X Switch Command Reference
mac address-table static
2-347