Programming Transmitters To The Vehicle; Battery Replacement - Hummer H2 2009 Owner's Manual

K
Pressing on the RKE transmitter disarms the content
theft-deterrent system. See Content Theft-Deterrent
on page 2-24.
K
Press and hold to lower the windows. See Power
Windows on page 2-20 for additional information.
The remote recall memory feature may adjust the seats
and mirrors if it is on and the RKE transmitter is used to
enter the vehicle. See "MEMORY SEAT RECALL" under
DIC Vehicle Customization on page 3-64 for additional
information.
L
(Vehicle Locator/Panic Alarm): Press and release
to locate the vehicle. The turn signal lamps flash and
the horn sounds three times.
L
Press and hold for more than two seconds to
activate the panic alarm. The turn signal lamps flash
and the horn sounds repeatedly for 30 seconds.
The alarm turns off when the ignition is moved to
L
RUN or is pressed again. The ignition must be
in OFF for the panic alarm to work.
2-6
Programming Transmitters to the
Vehicle
Only RKE transmitters programmed to the vehicle will
work. If a transmitter is lost or stolen, a replacement
can be purchased and programmed through your
dealer/retailer. When the replacement transmitter is
programmed to the vehicle, all remaining transmitters
must also be programmed. Any lost or stolen
transmitters no longer work once the new transmitter
is programmed. Each vehicle can have up to eight
transmitters programmed to it. See "Relearn Remote
Key" under DIC Operation and Displays (Using
DIC Buttons) on page 3-47 or DIC Operation and
Displays (Using Trip Odometer Reset Stem) on
page 3-52.

Battery Replacement

Replace the battery if the REPLACE BATTERY
IN REMOTE KEY message displays in the DIC.
See "REPLACE BATTERY IN REMOTE KEY" under
DIC Warnings and Messages on page 3-56 for additional
information.
Notice: When replacing the battery, do not touch
any of the circuitry on the transmitter. Static
from your body could damage the transmitter.