Multi-Function Digital Output 1 - Omron SYSDRIVE 3G3MV User Manual

Basic Operation
For n101, set the origin search deceleration time to the time required to go from 100%
·
to 0% of the maximum frequency.
If 0 is set for the origin search deceleration time, operation will be carried out at the
·
default setting of 2.0 seconds.
For n102, set the operating level as a percentage, with the Inverter's rated input taken
·
as 100%. If the Inverter's output current drops below the level of the Inverter's output
current, the speed search will be completed and acceleration will be resumed.
5-10-2 Multi-function digital Output
The 3G3MV incorporates three multi-function digital output terminals: one
multi-function contact outputs (MA-MC) and two multi-function photocoup-
ler outputs (P1 and P2).
Output from these terminals has a variety of functions according to the
application.
H Selecting the Multi-function digital Output (n050 through n056)

Multi-function digital Output 1

n057
(MA/MB and MC)
Setting 1 to 7, 10 to 21 (see note)
range
n058 Multi-function digital Output 2
(P1 and PC)
Setting 1 to 7, 10 to 21 (see note)
range
Multi-function digital Output 3
n059
(P2 and PC)
Setting 1 to 7, 10 to 21 (see note)
range
Set values 20 and 21 are available for 5.5- and 7.5-kW Inverters only.
Note
Set Values
Value Function
0 Fault output
1 Operation in progress ON: Operation in progress (with RUN command input or
2 Frequency detection
5-38
Register 0139
Unit of
setting
Register 013A
Unit of
setting
Register 013B
Unit of
setting
ON: Fault output (with protective function working)
inverter output)
ON: Frequency detection (with frequency reference
coinciding with output frequency)
Changes during
Hex operation
1 Default setting
Changes during
Hex operation
1 Default setting
Changes during
Hex operation
1 Default setting
Description
Chapter 5
No
0
No
1
No
2