Monitor Functions - Omron SYSDRIVE 3G3MV User Manual

Communications
Note 2. No data can be written to multi-function input.
Note 3. The unit of setting of the broadcast message is different from that in the DSR
message to communicate with a single Slave.
D RUN Command (Register 0001 Hex)
Bit No.
0
1
2
3
4 to 15

7-6-2 Monitor Functions

Register No.
(Hex)
0020 Status signal
0021 Fault status 1
0022 Data link status
0023 Frequency reference
0024 Output frequency
0025 to 0026 Not used
0027 Output current
0028 Output voltage
0029 Fault status (see note 2)
002A Warning (see note 2)
002B Input terminal status
002C Inverter status
002D Output terminal status
002E
002F to 0030 not used
0031 Main circuit DC voltage
0032 Torque reference
0033 to 0034 Not used
0035
0036 Not used
0037 Output power
0038 PID feedback
7-26
RUN command (1: RUN)
Forward/Reverse (1: Reverse)
External fault (1: External fault EF0)
Fault reset (1: Fault reset)
Not used
Function
Function
Description
Refer to the following corresponding table.
Refer to the following corresponding table.
Refer to the following corresponding table.
According to the set value in n152.
According to the set value in n152.
---
Read based on 1 A as 10.
Read based on 1 V as 1.
Refer to the following corresponding table.
Refer to the following corresponding table.
Refer to the following corresponding table.
Refer to the following corresponding table.
Refer to the following corresponding table.
Refer to the following corresponding table.
---
Read based on 1 V as 1.
Read based on ±1% as ±1 and the rated
motor torque is 100%.
---
Read based on 1 [h] as 1
---
Read based on ±1 kW as ±100.
Read based on 1% as 10 and a value
equivalent to the maximum frequency as
100%.
Chapter 7