Omron SYSDRIVE 3G3MV User Manual page 238

Communications
·The following memory allocations are made in the above example.
Note Control data on the SYSMAC
C200HX/HG/HE is indicated.
The SYSMAC CS1 Series uses
different control data.
H Creating a New Project and Protocol
1. Select New from the File in the Menu Bar or click on the New icon with the left button
of the mouse to create a new project.
2. If CX-Protocol is used, set the PC name, PC model, and network type according to
the actual conditions.
Note 1. The network type refers to the type of the network connected to the Support
Software and it does not refer to the communications configuration between the
Programmable Controller and the 3G3MV Inverter.
Note 2. The above settings will not be displayed if the Protocol Support Tool is used.
3. Double-click on New Project with the left button of the mouse to display List of Pro-
tocols.
4. Click on List of Protocols with the left button of the mouse and click on a blank
space with the right button of the mouse.
5. Select New Protocol.
7-44
SYSMAC CS1-series or C200HX/HG/HE
Programmable Controllers
C: Control data (see note)
Communica-
tions port
1: Port A
2: Port B
Data
No. of data items send in accordance with PMCR
instruction (000A)
No. of Slaves (0003)
First Slave address (0001)
RUN command to Slave 1
Frequency reference to Slave 1
Second Slave address (0002)
RUN command to Slave 2
Frequency reference to Slave 2
Third Slave address (0003)
RUN command to Slave 3
Frequency reference to Slave 3
No. of data items received in accordance with
PMCR instruction (0003)
Slave 1 Inverter status
Slave 2 Inverter status
Slave 3 Inverter status
Communications
Board
Sequence No.
000 to 999 (BCD)
Chapter 7
3G3MV