Outline Of Operation - Omron SYSDRIVE 3G3MV User Manual

Preparing for Operation and Monitoring
Appearance
Note For safety reasons, the reset will not work while a RUN command (forward or reverse) is in effect.
Wait until the RUN command is OFF before resetting the Inverter.

3-1-2 Outline of Operation

H Selecting Indicators
Whenever the Mode Key is pressed, an indicator is lit in sequence begin-
ning with the FREF indicator. The data display indicates the item corre-
sponding to the indicator selected.
The FOUT or IOUT indicator will be lit by turning the Inverter ON again if the
Inverter is turned OFF while the FOUT or IOUT indicator is lit. The FREF
indicator will be lit by turning the Inverter ON again if the Inverter is turned
OFF while an indicator other than the FOUT or IOUT indicator is lit.
Name
PRGM indicator
Mode Key
Increment Key
Decrement Key
Enter Key
RUN Key
STOP/RESET
Key
The parameters in n001 through n179 can be set
or monitored while this indicator is lit.
Note While the Inverter is in operation, the
parameters can be only monitored and
only some parameters can be changed.
The RUN command input is ignored
while this indicator is lit.
Switches the simplified-LED (setting and
monitor) item indicators in sequence.
Parameter setting being made is canceled if this
key is pressed before entering the setting.
Increases multi-function monitor numbers,
parameter numbers, and parameter set values.
Decreases multi-function monitor numbers,
parameter numbers, and parameter set values.
Enters multi-function monitor numbers,
parameter numbers, and internal data values
after they are set or changed.
Starts the Inverter running when the 3G3MV is in
operation with the Digital Operator.
Stops the Inverter unless parameter n007 is set
to disable the STOP Key. Functions as a Reset
Key when an inverter error occurs (see note).
Chapter 3
Function
3-3