Omron SYSDRIVE 3G3MV User Manual page 152

Advanced Operation
·Normally, the default settings do not need to be changed. If the motor stalls or stops
because the internal constants of the motor are special, increase the set values by
approximately 5% to 10%.
Output voltage
lower limit (%)
n159 Energy-saving Voltage
Upper Limit at 60-Hz Output
Setting 0 to 120 (%)
range
Energy-saving Lower Limit
n160
Voltage at 6-Hz Output
Setting 0 to 25 (%)
range
Set Values
·These parameters prevent the motor from over excitation due to voltage changes dur-
ing energy-saving control.
·Set the upper limit of output voltage in percentage at each frequency based on the
rated motor voltage as 100%.
·Normally, the default settings do not need to be changed.
Output voltage
upper limit (%)
Probe Operation Voltage
n144
Limit
Setting 0 to 100 (%)
range
6-10
Output frequency (Hz)
Register 019F
Hex
Unit of 1%
setting
Register 01A0
Hex
Unit of 1%
setting
Output frequency (Hz)
Register 0190
Hex
Unit of 1%
setting
Chapter 6
Changes during No
operation
Default setting 120
Changes during No
operation
Default setting 16
Changes during No
operation
Default setting 0