Omron SYSDRIVE 3G3MV User Manual page 132

Basic Operation
Set Values
Value Function
0 Forward/Reverse
rotation command
1 Forward/Stop
2 Reverse/Stop
3 External fault (NO)
4 External fault (NC)
5 Fault reset
6 Multi-step speed
reference 1
7 Multi-step speed
reference 2
8 Multi-step speed
reference 3
9 Multi-step speed
reference 4
10 Inching frequency
command
11 Acceleration/Decel-
eration time selection
12 External base block
command (NO)
13 External base block
command (NC)
14 Search command
(Searching starts
from maximum
frequency)
15 Search command
(Searching starts
from preset
frequency)
3-wire sequence (to be set in n052 only)
By setting n052 to 0, the set values in n050 and n051
are ignored and the following settings are forcibly
made.
S1: RUN input (RUN when ON)
S2: STOP input (STOP when OFF)
S3: Forward/Reverse rotation command
(OFF: Forward; ON: Reverse)
Forward rotation command in 2-wire sequence
Reverse rotation command (2-wire sequence)
ON: External fault (EFj detection: j is a terminal
number)
OFF: External fault (EFj detection: j is a terminal
number)
ON: Fault reset (disabled while RUN command is input)
Signals to select frequency references 2 through 16.
Note Refer to 5-6-4 Setting the Frequency References Note Refer to 5-6-4 Setting the Frequency References
through Key Sequences for the relationship
between multi-step speed references 1 through 4 between multi-step speed references 1 through 4
and frequency references 1 through 16.
Note Any multi-step speed reference not set is regarded Note Any multi-step speed reference not set is regarded
as turned-OFF input.
ON: Inching frequency command (taking preference
over the multi-step speed reference)
ON: Acceleration time 2 and deceleration time 2 are
selected.
ON: Output turned OFF (while motor coasting to a stop
and "bb" flashing)
OFF: Output turned OFF (with motor free running and
"bb" flashing)
ON: Speed search (Searching starts from n011)
ON: Speed search
Description
Chapter 5
5-33