Omron SYSDRIVE 3G3MV User Manual page 82

Preparing for Operation and Monitoring
D Parameter Settings in n001
Key Indicator
sequence
In
approximately
1 s.
H Reading the Parameter Set Value (rEd)
·To read the parameter set values in the Inverter with the EEPROM of the Digital Opera-
tor, set n176 for parameter copy function selection to rEd.
D Procedure to Read the Parameter Set Values
Key Indicator
sequence
Completes
or
3-14
Display
example
Power ON
Press the Mode Key repeatedly until the
PRGM indicator is lit.
Check that "n001" is displayed.
Press the Enter Key.
The data of the specified parameter number
is displayed.
Press the Increment Key repeatedly to
display the figure "4." At that time the display
flashes.
Press the Enter Key so that the set value will
be entered and the data display will be lit.
The parameter number will be displayed
again in approximately 1 s.
Display
example
Check that the PRGM indicator is lit. If the
PRGM is not lit, press the Mode Key
repeatedly until the PRGM indicator is lit.
Use the Increment or Decrement Key to
display n176.
Press the Enter Key. Then "rdy" will be
displayed.
Use the Increment Key to display "rEd."
Press the Enter Key so that the parameter
set values in the Inverter will be read by the
EEPROM of the Digital Operator, during
which the display flashes.
When the set values have been all read,
"End" will be displayed.
Press the Mode or Enter Key. The parameter
number (n176) will be displayed again.
Chapter 3
Explanation
Explanation