Omron SYSDRIVE 3G3MV User Manual page 83

Preparing for Operation and Monitoring
Note Be sure to set n177 for parameter read-prohibit selection to 1 so that the parame-
ters can be read.
H Copying the Data in the EEPROM of the Digital Operator to
another Inverter (CPy)
·To copy the parameter set values to another Inverter from the EEPROM of the Digital
Operator, set n176 for parameter copy function selection to CPy.
·When the parameter set values have been read, turn OFF the Inverter and remove the
Digital Operator. Refer to 2-1-3 Removing and Mounting the Covers for details.
·Mount the Digital Operator to the Inverter to which the parameters are copied. Then
turn ON the Inverter.
·Check that n001 for parameter write-prohibit selection/parameter initialization is set to
4 in the Inverter (i.e., values can be set in n001 through n179). If n001 is not set to 4,
take the steps described above and set n002 to 4.
Note The above procedure is possible provided that the Inverters are the same in
power supply specification and control mode (i.e., V/f or vector control).
D Procedure to Copy the Parameter Set Values
Key Indicator
sequence
Completes
or
Note 1. Check and verify the set ranges and set values of the parameters written to the
Inverter. If any error is found as a result, all the parameter set values will be pro-
hibited and the previous values will be reset.
Display
example
Power ON
Press the Mode Key repeatedly until the
PRGM indicator is lit.
Use the Increment or Decrement Key to
display "n176."
Press the Enter Key. Then "rdy" will be
displayed.
Use the Increment Key to display "CPy."
Press the Enter Key so that the parameter
set values in the EEPROM of the Digital
Operator will be copied to the Inverter, during
which the display flashes.
When the set values have been all copied,
"End" will be displayed.
Press the Mode or Enter Key. The parameter
number (n176) will be displayed again.
Chapter 3
Explanation
3-15