Omron SYSDRIVE 3G3MV User Manual page 236

Communications
Parameter
Next process
Error processing
H Data Created by Protocol Support Tool
·A project file is used by the Protocol Support Tool to create and control data.
A project file consists of the following data.
Single project file
Protocol name
(Single protocol)
Note The standard system protocol incorporated by the Communications Board can-
not be edited or transferred. To make use of the standard system protocol, copy it
to the project file and edit it.
In 7-9-4 Creating a Project File, an example to create a new project file is shown
without making use of the standard system protocol.
7-42
Determines which step is to be processed next or
finishes the operation after the step is finished
normally.
Determines which step is to be processed next or
finishes the operation, if the step has an error.
Protocol list
Trace list
PC
Sequence 000/Sequence name
Sequence 001/Sequence name
Sequence 999/Sequence name
Send message list
Recv message list
Recv matrix
Sequence #jjj
Description
Protocol name
Protocol name
Protocol name
Message name
Message name
Message name
Message name
Matrix name
Matrix name
Step 00
Step 01
Step 15
Chapter 7
A maximum of 20
protocols (A maximum of
1,000 sequences per
project)
A maximum of 60
sequences/protocol
The first sequence
number and last
sequence number are
specified by each
protocol.
A maximum
of 300
messages
A maximum
of 100
matrixes
A maximum of 16 steps