Setting Frequency References Through Key Sequences - Omron SYSDRIVE 3G3MV User Manual

Basic Operation
5-6-4 Setting Frequency References through Key
Sequences
The following description provides information on parameters related to
frequency reference settings through key sequences on the Digital Opera-
tor
H Frequency Reference Setting/Decimal Place Selection (n035)
·Set the unit of frequency reference and frequency-related values to be set or moni-
tored in n035 through the Digital Operator.
·The frequency reference value will be set in 0.01-Hz increments if the frequency is less
than 100 Hz and 0.1-Hz increments if the frequency is 100 Hz or over.
Frequency Reference Setting/
n035
Decimal Place Selection
Setting 0 to 3,999
range
Set Values
Value
0 Less than 100 Hz: 0.01-Hz increments
100 Hz or over: 0.1-Hz increments
1 0.1% increments (Max. frequency: 100%)
2 to 39 1-rpm increments (number of motor poles)
40 to Unit setting
3,999
The value to be set or monitored at max. frequency
jjjj
Note To display 50.0 for example, set the value to 1500. (see note)
Note The unit of setting of each parameter and monitor item below varies with the deci-
mal place.
Parameters
n024 to n032: Frequency references 1 through 8 and inching frequency command
n120 through n127: Frequency references 9 through 16
Monitor Items
U-01: Frequency reference monitor
U-02: Output frequency monitor
Description
Three digits
Decimal place
Register 0123 Changes during
Hex operation
Unit of 1 Default setting
setting
Chapter 5
No
0
5-19