Nortel 1000 Features And Services Fundamentals page 243

Prompt Response
TYPE: 2250
TN
l s c u
c u
CPND (CNDD) CNDA
DNDI (DNDD) DNDA
Change or remove names in the CPND data block
LD 95 - Open the CPND data block to change or remove entries.
Prompt Response
REQ CHG OUT
TYPE NAME
xx
CUST
LANG ROM KAT ALL
0-2045 0-99
DIG
ALL <CR>
- NAME aaaa bbbb
<CR>
DN xxx...x
ALL
<CR>
- NAME aaaa bbbb
xxx
DCNO
nnn
- IDC
NAME aaaa bbbb
Copyright © 1994–2008, Nortel Networks
.
Description
Attendant console type.
Terminal number
Format for Large System and CS 1000E system,
where l = loop, s = shelf, c = card, u = unit.
Format for Small System and Media Gateway 1000B where c =
card and u = unit.
(Deny) allow CPND name assignment.
(Deny) allow display of originally dialed CPND entries.
Description
Change, or remove an existing entry.
Change, or remove an existing CPND name string.
Customer number, as defined in LD 15
Change or remove the name in Roman or Katakana. ALL is
used to remove all names stored for the DIG.
Dial Intercom Group number and member number. Each time
a name string is assigned to or removed from a Dial Intercom
Group member, the DIG prompt repeats, until a carriage return
is entered to go to the DN prompt. ALL removes all entries for
that DIG. <CR> bypasses DIG and goes to the DN.
CPND name string for this DIG; maximum of 27 characters.
Leave this entry unchanged.
DN of name string being changed or removed.
Remove all DN-defined entries.
Return to REQ prompt.
CPND name string; maximum of 27 characters.
IDC conversion table number (0-254).
Existing complete or partial IDC number.
Prompted only when DCNO is valid.
CPND name string; maximum of 27 characters.
Nortel Communication Server 1000
Features and Services Fundamentals — Book 2 of 6 (C)
NN43001-106 02.04 Standard
Release 5.5 9 May 2008
Feature implementation 243