Nortel 1000 Features And Services Fundamentals page 212

212 Call Hold, Permanent
Feature implementation
Task summary list
The following is a summary of the tasks in this section:
1.
2.
LD 15 - Enable/disable Permanent Hold reminder ring timer for the customer.
Prompt Response
REQ: CHG
TYPE: TIM
CUST
0-99
0-31
- PHDT 1-(30)-63
LD 10 - Enable/disable Permanent Hold for 2500 telephones.
Prompt Response
REQ: CHG
TYPE: 500
TN
l s c u
c u
CLS XFA
FTR PHD
Feature operation
To place a call on hold, follow these steps:
•
•
•
Copyright © 1994–2008, Nortel Networks
.
"LD 15 - Enable/disable Permanent Hold reminder ring timer for the
customer." (page 212)
Enable/disable Permanent Hold reminder ring timer for the customer.
"LD 10 - Enable/disable Permanent Hold for 2500 telephones." (page
212)
Enable/disable Permanent Hold for 2500 telephones.
Description
Change existing data.
Timers.
Customer number.
Range for Large System and CS 1000E system.
Range for Small System and Media Gateway 1000B.
Permanent Hold reminder ring timing in two-second increments
(that is, 30 = 60 seconds).
Description
Change existing data.
Telephone type.
Terminal number.
Format for Large System and CS 1000E system,
where l = loop, s = shelf, c = card, u = unit.
Format for Small System and Media Gateway 1000B where c =
card and u = unit.
Allow transfer.
Enable Permanent Hold.
While on an active call, flash the switchhook, or press the Link key.
Dial #4, or the Flexible Feature Code (FFC), if enabled.
Hang up.
Nortel Communication Server 1000
Features and Services Fundamentals — Book 2 of 6 (C)
NN43001-106 02.04 Standard
Release 5.5 9 May 2008