Nortel 1000 Features And Services Fundamentals page 550

550 Collect Call Blocking
Prompt Response
M911_ANI NO
...
ISDN NO
...
ICOG IAO ICT OGT
...
CNTL (NO) YES
...
CCB (NO) YES
CCB1 512-(1536)-4992
CCB2 500-(1520)-2550
CCBA (NO) YES
LD 14 - Setup the firmware timing for XFCOT and EXUT cards.
Prompt Response
REQ NEW
CHG
TYPE DID COT FEX
WAT
TN
l s c u
c u
XTRK EXUT
XCOT
Copyright © 1994–2008, Nortel Networks
.
Description
M911 route. Must be set to NO to enable CCB.
ISDN route. Must be set to NO to enable CCB.
Incoming and outgoing, incoming, or outgoing. Must be
either IAO or ICT to enable CCB.
Must be either IAO or OGT to get the CCBA prompt for
outgoing calls.
Change to controls or to timers.
Collect Call Blocking enabled or disabled on incoming
route. CCB package 290 is required. Enter YES to obtain
CCB timer prompts.
Collect Call Blocking delay timer 1 in milliseconds. Input
rounded to the next multiple of 128 milliseconds.
Collect Call Blocking delay timer 2 in milliseconds. Input
rounded to the next multiple of 10 milliseconds. If any CCB
route members (trunks) are using firmware timing (FWTM
= YES in LD 14), changes to the CCB2 timer value will not
take effect until the new timer value is downloaded to the
card. This can be done by enabling the card or initializing
the switch.
Collect Call Blocking allowed or denied for outgoing route.
Description
Add.
Change.
Trunk Type.
Terminal number
Format for Large System and CS 1000E system,
where l = loop, s = shelf, c = card, u = unit.
Format for Small System and Media Gateway 1000B where
c = card and u = unit.
Type of card.
Nortel Communication Server 1000
Features and Services Fundamentals — Book 2 of 6 (C)
NN43001-106 02.04 Standard
Release 5.5 9 May 2008