Nortel 1000 Features And Services Fundamentals page 186

186 Call Forward, Remote (Attendant and Network Wide)
3
4
5
Copyright © 1994–2008, Nortel Networks
.
If a password is not required, the console display will show the DN
of the set to be forwarded followed by the CFW DN stored on that
set. The RFW key lamp will display the status of the CFW DN. If the
RFW lamp is flashing, CFW is not active; if the RFW lamp is steady
lit, CFW is active. Proceed to Step 4.
Dial the password followed by #.
Expected Result: The console display will show the DN of the
set to be forwarded followed by the CFW DN stored on that set.
The RFW key lamp will display the status of the CFW DN. If the
RFW lamp is flashing, CFW is not active; if the RFW lamp is steady
lit, CFW is active.
The user can now enter a new CFW DN or press the RFW key to
activate or deactivate the stored CFW DN.
Expected Result: The console display will show the DN of the set to
be forwarded followed by the CFW DN. If the RFW lamp is flashing,
CFW is not active; if the RFW lamp is steady lit, CFW is active.
When RCFW operation is in this state, the user has the following
three options:
• Press the Release or Release Source key to terminate RCFW
operation.
•
Press the RFW key to reverse the CFW status.
• Enter a new CFW DN to begin the task of changing the CFW DN
programmed. The new CFW DN is not active until the RFW key
is pressed again.
Error Condition: If an error should occur during the attendant-based
RCFW, the user is presented with an Overflow tone. To remove
the error condition, the user must release from the operation and
begin again.
Nortel Communication Server 1000
Features and Services Fundamentals — Book 2 of 6 (C)
NN43001-106 02.04 Standard
Release 5.5 9 May 2008
—End—