Nortel 1000 Features And Services Fundamentals page 557

LD 56 - Configure Conference Warning Tone
Prompt Response
REQ CHG
TYPE FTC
0
TABL
...
RING NO
HCCT YES
...
- EEST NO
- CFWT
- - XTON 0-(3)-255
- - XCAD 0-(19)-255
LD 97 - Enable Conference Warning Tone
Prompt Response
REQ CHG
TYPE XCTP
CPAD
(0)
1
DTMF 0-(14)-255
CFWT (NO) YES
LD 34 - Enable Conference Warning Tone
Command Description
ENLX l Enable Conf/TDS/MFS card on loop l and l + 1.
DISX l Disable Conf/TDS/MFS card on loop l and l + 1.
Copyright © 1994–2008, Nortel Networks
.
Description
Modify existing data.
Flexible Tones and Cadences data block.
FTC table number 0. Only table number 0 can be used to
make changes to the Conference Warning Tone.
Modify the ringing feature definitions.
Modification of the hardware controlled cadence tone
definitions allowed.
End-to-end Signaling type.
Conference Warning Tone.
The Conference Warning Tone number. A tone number
provided by the tone circuit.
The Conference Warning Tone cadence number. Cadence
number must have been previously set up within LD 56 by
responding to the TYPE prompt with FCAD.
Description
Modify existing data.
Conference/TDS/MF Sender card parameters.
Conference pad values.
Use software pad values.
Use pad values defined by switch settings.
Tone table of the first Dual-tone Multifrequency digit to be
used.
(Disable) enable Conference Warning Tone.
Note: For CS 1000E Release 5.0 and later, LD 34 must be
used to Enable/Disable Conference Warning Tone.
Nortel Communication Server 1000
Features and Services Fundamentals — Book 2 of 6 (C)
NN43001-106 02.04 Standard
Release 5.5 9 May 2008
Feature implementation 557