Nortel 1000 Features And Services Fundamentals page 492

Book 2 of 6 (c)
Table of Contents

Advertisement

492 CIS Toll Dial Tone Detection
Prompt
Response
- TIMR
ATO 128-(4992)-
65408
...
...
CISR
YES
- DTOC
(NO) YES
- CTOC
(DTDO)
AADT
ANIO
AODT
- COAT
(NO) YES
Feature operation
No specific operating procedures are required to use this feature.
Copyright © 1994–2008, Nortel Networks
.
Description
ANI timeout timer in milliseconds. For CIS outgoing trunk routes
this defines the time delay performed after the out-pulsing
of the toll access code. During this delay further out-pulsing
is temporarily halted until the special message from the card
firmware confirms the satisfaction of the CIS Toll out-pulsing
criteria. If the timer expires before satisfaction the behavior of
the system depends on the COAT prompt. If COAT is set to
YES the out-pulsing continues on timeout. If COAT is set to
NO the call is dropped.
...
CIS Route
Deny/Allow Direct Toll Connection.
CIS Toll Outpulsing Criteria.
DTD Only.
ANI And DTD.
ANI Only.
ANI Or DTD.
NO = Drop Call when ATO timer expires.
YES = Continue Outpulsing when ATO timer expires.
Nortel Communication Server 1000
Features and Services Fundamentals — Book 2 of 6 (C)
NN43001-106 02.04 Standard
Release 5.5 9 May 2008

Advertisement

Table of Contents
loading

Table of Contents