T1 Service - AT&T MERLIN LEGEND Release 3.1 System Planning Manual

Communications system
Hide thumbs Also See for MERLIN LEGEND Release 3.1:
Table of Contents

Advertisement

Selecting Line/Trunk Options
Planning Form Instructions
On Form 2c, System Numbering: Line/Trunk Jacks:
1. For all trunks listed as "PRI" in the Jack Type column:
NOTE:
You cannot use Channel 24 for services.
a. Write the kind of service to be connected to each channel in the
Incoming Line/Trunk Type column.
b. Write
channel not used at this time.
2. For all trunks listed as T1-Tie that do not show an
Incoming Line/Trunk Type column, write the kind of service connected to
each channel in the Incoming Line/Trunk Type column.
NOTE:
If you use common-channel signaling, you cannot use Channel 24 and
program the module for tie-trunk emulation.
3. Do one of the following:
To select settings for T1 and T1 Switched 56, continue to the next
section, "T1 Service." For T1 Switched 56 service, you must also
complete the "T1 Switched 56" section.
To select settings for PRI, skip to "PRI Service."

T1 Service

T1 service allows the emulation of different analog lines. You can also order
services, such as Megacom 800, over the channels. The capacity, however, is
limited to voice calls and data calls using a modem. In addition, with Release
4.0 of the MERLIN LEGEND Communications System, T1 supports ACCUNET
Switched Digital Service (or other circuit-switched data service) at 56-kbps
when the T1 channel or T1-Tie trunk is configured as T1 Switched 56.
The planning form instructions below apply to both T1 and T1 Switched 56
service except where noted. If you are configuring channels for T1 Switched 56
service, complete these instructions then proceed to the "T1 Switched 56 –
Network" section that immediately follows. If configuring T1-Tie trunks for T1
Switched 56 service, proceed to the "Tie Trunks" section after completing these
instructions.
Planning Form Instructions
On Form 3b (page 1), Incoming Trunks: DS1 Connectivity (100D Module), for
each 100D module in the system:
3–22
Lines/Trunks
unequipped
in the Incoming Line/Trunk Type column for any
unequipped
entry in the

Advertisement

Table of Contents
loading

This manual is also suitable for:

Merlin legend 4.0

Table of Contents