Rj-45 Connector Pinouts For The M7I Routing Engine Mgmt Port; Db-9 Connector Pinouts For The M7I Routing Engine Aux/Modem And Console Ports; Table 53: Rj-45 Connector Pinout - Juniper M7i Hardware Manual

M7i Multiservice Edge Router Hardware Guide

RJ-45 Connector Pinouts for the M7i Routing Engine MGMT Port

Related
Documentation

DB-9 Connector Pinouts for the M7i Routing Engine AUX/MODEM and CONSOLE Ports

98
The port on the Routing Engine labeled
RJ-45 receptacle that accepts an Ethernet cable for connecting the Routing Engine to a
management LAN (or another device that supports out-of-band management).
Table 53 on page 98 describes the RJ-45 connector pinout.

Table 53: RJ-45 Connector Pinout

Pin Signal
1 TX+
2 TX-
3 RX+
4 Termination network
5 Termination network
6 RX-
7 Termination network
8 Termination network
M7i Routing Engine Description on page 17
Maintaining the M7i Routing Engine on page 192
Replacing the M7i Routing Engine on page 141
Replacing the Routing Engine Interface Port Cables on page 144
DB-9 Connector Pinouts for the M7i Routing Engine AUX/MODEM and CONSOLE Ports
on page 98
The ports on the CIP labeled
accept RS-232 (EIA-232) cable. The
a laptop, modem, or other auxiliary unit, and the
management console. The ports are configured as data terminal equipment (DTE).
Table 54 on page 99 describes the DB-9 connector pinouts.
is an autosensing 10/100-Mbps Ethernet
MGMT
AUX/MODEM and CONSOLE
port connects the Routing Engine to
AUX/MODEM
CONSOLE
Copyright © 2019, Juniper Networks, Inc.
are DB-9 receptacles that
port connects it to a