Appendix F M40E Cable Connector Pinouts; Rj-45 Connector Pinouts For The M40E Routing Engine Mgmt Port; Table 33: Rj-45 Connector Pinout - Juniper M40E Hardware Manual

APPENDIX F
M40e Cable Connector Pinouts

RJ-45 Connector Pinouts for the M40e Routing Engine MGMT Port

Copyright © 2010, Juniper Networks, Inc.
All manuals and user guides at all-guides.com
RJ-45 Connector Pinouts for the M40e Routing Engine MGMT Port on page 289
DB-9 Connector Pinouts for the M40e Routing Engine AUX/MODEM and CONSOLE
Ports on page 290
RJ-48 Cable Pinouts for E1 and T1 PICs on the M40e Router on page 290
DB-9 Connector Pinouts for the M40e CIP BITS Input Ports on page 293
M40e X.21 and V.35 Cable Pinouts for EIA-530 PIC on page 294
M40e Fast Ethernet PIC 48-port Cable Pinouts on page 296
The port on the CIP labeled
receptacle that accepts an Ethernet cable for connecting the Routing Engine to a
management LAN (or another device that supports out-of-band management). Table
33 on page 289 describes the RJ-45 connector pinout.

Table 33: RJ-45 Connector Pinout

Pin Signal
1 TX+
2 TX-
3 RX+
4 Termination network
5 Termination network
6 RX-
7 Termination network
8 Termination network
MGMT is an autosensing 10/100-Mbps Ethernet RJ-45
289