Figure 36: Removing the Center-Mounting Bracket
Craft interface
Fan tray
FPCs
CIP
ESD point
Air filter
Fan tray
Air intake
Removing the Spacer Bars
Related
Documentation
Copyright © 2013, Juniper Networks, Inc.
Front-mounting flange
Center-mounting bracket
The router is shipped with each spacer bar attached to the rear of each front-mounting
flange. If you are installing the chassis in an open-frame rack, removing the spacer bars
is optional.
To remove the spacer bars:
Remove the screws that fasten the spacer bar to the front-mounting flange
1.
Remove the spacer bars.
2.
Rack Requirements for the T4000 Router on page 58
Installing the T4000 Mounting Hardware for a Four-Post Rack or Cabinet on page 67
Chapter 7: Installing the T4000 Router Mounting Hardware
73