Relay Host - Novell GROUPWISE 8 - ADMINISTRATION Administration Manual

/te
Specifies how long the program waits for the receiving host to establish a connection. The default is
5 minutes.
Syntax: /te-minutes
Example: /te-2
/tg
Specifies how long the program waits for the initial greeting from the receiving host. The default is
3 minutes.
Syntax: /tg-minutes
Example: /tg-2
/tr
Specifies how long the program waits for a TCP read. The default is 10 minutes.
Syntax: /tr-minutes
Example: /tr-2
/tt
Specifies how long the program waits for the receiving host to terminate the connection. The default
is 5 minutes.
Syntax: /tt-minutes
Example: /tt-2

52.6.10 Relay Host

The following switch configures whether or not the Internet Agent uses a relay host.
/mh
/mh
Specifies the IP address or DNS hostname of one or more relay hosts that you want the Internet
Agent to use for outbound messages. Use a space to separate multiple relay hosts in a list.
The relay host can be part of your network or can reside at the Internet service provider's site. This
switch is typically used in firewall integration if you want one server, the specified relay host, to
route all mail. See Section 46.1.1, "Configuring Basic SMTP/MIME Settings," on page 731.
Syntax: /mh-address
Example: /mh-172.16.5.18
858 GroupWise 8 Administration Guide