Novell GROUPWISE 8 - ADMINISTRATION Administration Manual page 693

With these default settings, the MTA always starts four scanner threads. You can deselect
either option so that the MTA starts fewer scanner threads
3 Deselect scanner thread options to allocate threads to priority subdirectories as shown in the
table below.
Priority
Primary Use
Directory
Busy searches wpcsin\0
GroupWise wpcsin\1
Remote user
requests
Administrative wpcsin\2
requests and
high priority
messages
High priority wpcsin\3
statuses
Normal priority wpcsin\4
messages
Normal priority wpcsin\5
statuses
Low priority wpcsin\6
messages
Low priority wpcsin\7
statuses
Total Scanner Threads in
Use:
4 Click OK to save the new scanner thread settings.
ConsoleOne then notifies the MTA to restart so the new setting can be put into effect.
Corresponding Startup Switches You can also use the
startup file to adjust the allocation of MTA scanner threads.
MTA Web Console You can check the current MTA scan cycle on the
the Performance Settings heading.
Two High
Two Scanner
Priority
Threads
Scanners
High priority High priority
scanner thread scanner thread
one
High priority
scanner thread
two
Mail priority Mail priority
scanner thread scanner thread
2 3
/fast0
Two Mail
Default
Priority
Operation
Scanners
High priority High priority
scanner thread scanner thread
one
High priority
scanner thread
two
Mail priority Mail priority
scanner thread scanner thread
one one
Mail priority Mail priority
scanner thread scanner thread
two two
3 4
and /fast4 switches in the MTA
Configuration page under
Optimizing the MTA 693