Novell GROUPWISE 8 - ADMINISTRATION Administration Manual page 540

Admin Thread Box The Admin Thread box displays the following information:
Status: Displays one of the following statuses:
Running: The POA admin thread is active.
Suspended: The POA admin thread is not processing administrative messages.
Starting: The POA admin thread is initializing.
Terminated: The POA admin thread is not running.
POA Web Console You can display POA admin thread status from the
the General Settings heading, click Admin Task Processing.
Recovering the Post Office Database Automatically or Immediately
The POA admin thread can recover the post office database (
To enable/disable automatic post office database recovery:
1 At the server where the POA is running, display the POA server console.
2 Click Configuration > Admin Status > Automatic Recovery to toggle this feature on or off for
the current POA session.
NetWare Note: Use Options (F10) > Admin Status > Automatic Recovery.
To change the setting permanently, see
page 489.
To recover the post office database immediately:
1 At the server where the POA is running, display the POA server console.
2 Click Configuration > Admin Status > Perform DB Recovery.
NetWare Note: Use Options (F10) > Admin Status > Perform DB Recovery.
For additional database repair procedures, see
Databases," on page
POA Web Console You can recover the post office database from the
the General Settings heading, click Admin Task Processing. Select Automatic Recovery or Perform
DB Recovery as needed.
Recovering User and Message Databases Automatically
The POA can recover user databases (
automatically when it detects a problem because databases can be open during the recover process.
This procedure is a "recover" rather than a "rebuild," because a "rebuild" requires that all users and
agents are out of the database being rebuilt. See
Message Databases," on page
To enable/disable automatic message and user database recovery:
1 At the server where the POA is running, display the POA server console.
2 Click Actions > Auto Rebuild to toggle this feature on or off for the current POA session.
NetWare Note: Use Options (F4) > Actions > Enable Auto Rebuild.
540 GroupWise 8 Administration Guide
Section 36.1.2, "Configuring the POA in ConsoleOne," on
393.
userxxx.db
401.
wphost.db
Chapter 26, "Maintaining Domain and Post Office
Configuration
) and message databases (
Chapter 27, "Maintaining User/Resource and
Configuration page. Under
) when it detects a problem.
page. Under
)
msgnnn.db