Novell GROUPWISE 8 - ADMINISTRATION Administration Manual page 503

3 Fill in the following fields:
Enable IMAP: Select Enable IMAP to turn on IMAP processing.
Max IMAP Threads: Specify the maximum number of IMAP threads you want to the POA to
start.
The default maximum number of IMAP threads is 40. This is adequate for most post offices,
because each IMAP thread can service multiple IMAP clients. By default, the POA creates 1
IMAP thread and automatically creates additional threads as needed to service clients until the
maximum number is reached. You cannot set the maximum higher than 40.
You might want to lower the maximum number of IMAP threads if IMAP processing is
monopolizing system resources that you prefer to have available for other processes. However,
insufficient IMAP threads can cause slow response for IMAP client users.
4 Click Apply to save the IMAP thread settings.
5 To secure IMAP connections to the post office:
5a Click GroupWise > Network Address
5b Select Required in the IMAP SSL drop-down list.
For additional instructions about using SSL connections, see
Certificates and SSL Encryption," on page
6 Click OK to save the IMAP settings and return to the main ConsoleOne window.
ConsoleOne then notifies the POA to restart with IMAP enabled.
Corresponding Startup Switches You can also use the /imap, /imapmaxthreads, /imapport,
imapssl, /imapsslport, and
POA to support IMAP clients.
POA Web Console You can see whether IMAP is enabled on the
General Settings heading.
/imapreadlimit startup switches in the POA startup file to configure the
Section 75.2, "Server
1161.
Configuration
/
page under the
Configuring the POA 503