Removing And Installing Parts Of The Abs System On The Rear Axle (Four-Wheel Drive) - Skoda Octavia II 2004 Workshop Manual

Octavia II 2004 ➤ , Octavia II 2010 ➤
Brake systems - Edition 11.2017
7.3 Removing and installing parts of the ABS system on the rear axle (four-
wheel drive)
1 - ABS wheel speed sensor
❑ clean the inner surface
of the hole before insert‐
ing the sensor and
brush over with a hot
bolt paste -
G 052 112 A3 - .
❑ Removing and installing
⇒ page 88
2 - Screw, 8 Nm
3 - Wheel hub with wheel bear‐
ing
❑ Sensor ring for ABS built
into the wheel bearing
7.3.1 Removing and installing the ABS speed
sensor on the rear axle
Removing:
– Raise vehicle.
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not permitted
unless authorised by ŠKODA AUTO A. S. ŠKODA AUTO A. S. does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by ŠKODA AUTO A. S.�
88