Skoda Octavia II 2004 Workshop Manual page 49

1 - ABS control unit - J104-
❑ Removing and installing
⇒ page 45
❑ Disconnecting the con‐
trol unit from the hy‐
draulic unit ⇒ page 51
❑ Fitting the control unit to
the hydraulic unit
⇒ page 52
2 - ABS hydraulic unit - N55-
❑ Removing and installing
⇒ page 45
3 - Screw, 5.5 Nm
4 - Brake line, 14 Nm
❑ from master brake cylin‐
der (push rod piston cir‐
cuit) to ABS hydraulic
unit
❑ Distinguishing feature:
pipe screw with thread
M12 x 1
5 - Brake line, 14 Nm
❑ from master brake cylin‐
der (floating piston cir‐
cuit) to ABS hydraulic
unit
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not permitted
❑ Distinguishing feature:
unless authorised by ŠKODA AUTO A. S. ŠKODA AUTO A. S. does not guarantee or accept any liability
pipe screw with thread
M12 x 1
6 - Brake line, 14 Nm
❑ to front left brake caliper
❑ Distinguishing feature
for vehicles up to CW
21/2008: pipe screw
with thread M12 x 1
❑ Distinguishing feature for vehicles as of CW 22/2008: pipe screw with thread M10 x 1
7 - Brake line, 14 Nm
❑ To front right brake caliper.
❑ Distinguishing feature for vehicles up to CW 21/2008: pipe screw with thread M10 x 1
❑ Distinguishing feature for vehicles as of CW 22/2008: pipe screw with thread M12 x 1
8 - Brake line, 14 Nm
❑ to rear left brake caliper
❑ Distinguishing feature: pipe screw with thread M12 x 1
9 - Brake line, 14 Nm
❑ to rear right brake caliper
❑ Distinguishing feature: Pipe screw with thread M10 x 1
10 - Pressure sensor for the brake servo unit -G294-
❑ only on vehicles with petrol engines with brake vacuum pump
❑ Removing and installing
❑ Check ⇒ Vehicle diagnostic tester
11 - Dummy plug
12 - Vacuum line
❑ with non-return valve
with respect to the correctness of information in this document. Copyright by ŠKODA AUTO A. S.�
⇒ page 185
5. Hydraulic Control Unit, Brake Servo Unit/Master Brake Cylinder ABS Mark 70 (ABS/TCS)
Octavia II 2004 ➤ , Octavia II 2010 ➤
Brake systems - Edition 11.2017
43