Removing And Installing Brake Pads, Brake Calliper Fn3 - Skoda Octavia II 2004 Workshop Manual

Octavia II 2004 ➤ , Octavia II 2010 ➤
Brake systems - Edition 11.2017
❑ repairing ⇒ page 155
7 - Guide bolt, 30 Nm
8 - Cap
❑ remove
9 - Brake hose with banjo union and hollow screw, 35 Nm
10 - Screw, 190 Nm
❑ clean when using again
11 - Screw, 15 Nm
12 - Mounting bracket
13 - Wheel bearing housing
❑ with bolted brake carrier
14 - ABS wheel speed sensor
❑ clean the inner surface of the hole before inserting the sensor and brush over with a hot bolt paste - G
052 112 A3- .
15 - Screw, 8 Nm
16 - Protection plate
17 - Screw 12 Nm
18 - Wheel hub with wheel bearing
❑ Sensor ring for ABS is built into the wheel hub
1.6 Removing and installing brake pads,
brake calliper FN3
Special tools and workshop equipment required
♦ Piston jig - T10145-
Removing:
Mark brake pads/linings when removing if they are to be reused.
Fit in same position when installing, or braking will be uneven!
– Remove wheels.
– Lever up the retaining spring of the brake pads out of the brake
caliper -arrow- using a screwdriver and remove.
104
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not permitted
unless authorised by ŠKODA AUTO A. S. ŠKODA AUTO A. S. does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by ŠKODA AUTO A. S.�