Lubrication System Page; Removing And Installing Parts Of The Lubrication System - Skoda OCTAVIA Workshop Manual

OCTAVIA

Removing and installing parts of the lubrication system

Notes:
♦ If considerable quantities of metal swarf or
abrasion are found in the engine oil when
carrying out repair work in the engine, it is
then necessary to carefully clean the oil gal-
leries and in addition to replace the oil cooler
in order to avoid any consequential damage.
♦ The oil level must not extend beyond the
max. marking - risk of damage to catalytic
converter!
♦ To extract oil, remove filler funnel on dipstick
guide tube.
♦ Testing compression ⇒ page 17-5.
Inspecting oil level, oil quantity, oil specification
⇒ Inspection and Maintenance
1 - Oil pump
♦ Duocentric pump
♦ with 1.2 MPa pressure relief valve
♦ before installing, check whether the
two dowel sleeves for centering oil
pump/cylinder block are fitted
♦ if scores present on running surfaces
and gears, replace
♦ torque for attaching oil pump cover to
oil pump housing: 10 Nm
Edition 11.02
S00.5110.56.20
Lubrication system
2 - Chain sprocket for oil pump
♦ pay attention to installation position
♦ can be fitted onto oil pump shaft only
in one position
3 - 25 Nm
4 - Chain for oil pump
♦ before removing, mark running direc-
tion
5 - Sealing flange
♦ removing and installing ⇒ page 13-18
♦ replacing crankshaft seal
⇒ page 13-15
6 - 15 Nm
7 - Collar bolt, 15 Nm
8 - Bush
9 - Chain tensioner
10 - Spring
11 - Washer
12 - Chain sprocket
13 - O-ring
♦ replace
14 - Suction line
♦ clean strainer if soiled
15 - Splash plate
16 - Oil pan
♦ removing and installing ⇒ page 17-3
17 - 10 Nm
18 - Oil level and oil temperature sender
-G266
♦ only for models with extended serv-
ice interval
♦ testing ⇒ Electrical system; Repair
Group 90
19 - Gasket
♦ replace if damaged
20 - Seal
♦ replace
21 - Oil drain plug, 30 Nm
17
------------ 17-1 ------------