Skoda Octavia II 2004 Workshop Manual page 61

Connect brake lines to the hydraulic unit.
A - from master brake cylinder (push rod piston circuit) to ABS
hydraulic unit
- Distinguishing feature for vehicles up to CW 21/2008: pipe screw
with thread M10 x 1
- Distinguishing feature for vehicles as of CW 22/2008: pipe screw
with thread M12 x 1
B - from master brake cylinder (floating piston circuit) to ABS hy‐
draulic unit
- Distinguishing feature: pipe screw with thread M12 x 1
1 - Hydraulic unit to front left brake caliper
- Distinguishing feature for vehicles up to CW 21/2008: pipe screw
with thread M12 x 1
- Distinguishing feature for vehicles as of CW 22/2008: pipe screw
with thread M10 x 1
2 - hydraulic unit to rear left brake caliper
- Distinguishing feature of pipe screw with thread M12 x 1
3 - hydraulic unit to rear right brake caliper
- Distinguishing feature: Pipe screw with thread M10 x 1
4 - Hydraulic unit to front right brake caliper
- Distinguishing feature for vehicles up to CW 21/2008: pipe screw
with thread M10 x 1
- Distinguishing feature for vehicles as of CW 22/2008: pipe screw
with thread M12 x 1
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not permitted
unless authorised by ŠKODA AUTO A. S. ŠKODA AUTO A. S. does not guarantee or accept any liability
5.8 Removing and installing ABS control
with respect to the correctness of information in this document. Copyright by ŠKODA AUTO A. S.�
unit - J104- / ABS hydraulic unit - N55- -
right-hand drive
Special tools and workshop equipment required
♦ Brake pedal load e.g. -V.A.G 1869/2-
Removing:
Fitting location:
The control unit is bolted to the hydraulic unit and is located on
the left in the engine compartment.
WARNING
The brake lines around the hydraulic unit must not be bent!
– Read out and note the actual control unit coding ⇒ Vehicle
diagnostic tester.
– Remove engine cover.
– Remove battery ⇒ Electrical System; Rep. gr. 27 .
– Remove inlet connection and air filter ⇒ Engine; Rep. gr. 23
or ⇒ Engine; Rep. gr. 24 .
– Remove battery ⇒ Electrical System; Rep. gr. 27 .
– Position brake pedal load , e.g. -V.A.G 1869/2- .
Octavia II 2004 ➤ , Octavia II 2010 ➤
Brake systems - Edition 11.2017
55