Skoda Octavia II 2004 Workshop Manual page 74

Octavia II 2004 ➤ , Octavia II 2010 ➤
Brake systems - Edition 11.2017
– Remove intake manifold flap motor - V157- ⇒ Engine; Rep.
gr. 23 (except vehicles with engine identification characters
BJB).
2.0 ltr. diesel engine:
– Remove bulkhead plenum chamber ⇒ Body Work; Rep. gr.
66 .
– Remove connection pipe between intake hose and exhaust
turbocharger.
– Remove top toothed belt guard.
Diesel engines with the diesel particle filter:
– Remove pre-exhaust pipe with diesel particle filter ⇒ diesel
engine; Rep. gr. 26 .
Continued for all vehicles:
– Release the in the -direction of arrow 1- and pull it off the con‐
trol unit in the -direction of arrow 2-.
– Position brake pedal load , e.g. -V.A.G 1869/2- .
– Attach the bleeder hose of the bleeding bottle onto the vent
valves of the front left and rear left brake caliper and open vent
valves.
– Press down brake pedal with brake pedal load , e.g. -
V.A.G 1869/2- , at least 60 mm.
– Close front left and rear left bleeder valves.
– Do not remove brake pedal load , e.g. -V.A.G 1869/2- .
– Place sufficient non-fluffing cloths under the control unit and
the hydraulic unit.
Note
Make sure that no brake fluid gets onto the contacts of the plug
connections.
68
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not permitted
unless authorised by ŠKODA AUTO A. S. ŠKODA AUTO A. S. does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by ŠKODA AUTO A. S.�