Skoda Octavia II 2004 Workshop Manual page 181

❑ if there are faults replace completely
❑ Removing and installing
❑ Assignment ⇒ Electronic Catalogue of Original Parts
11 - Brake light switch -F- and brake pedal switch -F47-
❑ installed from 11/05
❑ Fitting location: on master brake cylinder
❑ Removing and installing
❑ Check ⇒ Vehicle diagnostic tester
12 - Screw, 5 Nm
13 - Protection plate
❑ Assignment ⇒ Electronic Catalogue of Original Parts
14 - Self-locking nut, 25 Nm
❑ replace after each removal
15 - Sealing grommets
❑ moisten with brake fluid and press in brake fluid reservoir
16 - Brake line, 14 Nm
❑ Master brake cylinder/push rod piston circuit to hydraulic unit
17 - Brake line, 14 Nm
❑ Master brake cylinder/push rod piston circuit THV to hydraulic unit
18 - Brake fluid reservoir
19 - Screw cap
– Check fitting position
⇒ page 186
⇒ page 139
⇒ page 177
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not permitted
unless authorised by ŠKODA AUTO A. S. ŠKODA AUTO A. S. does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by ŠKODA AUTO A. S.�
5. Summary of Components: brake servo unit/master brake cylinder
Octavia II 2004 ➤ , Octavia II 2010 ➤
Brake systems - Edition 11.2017
175