Skoda Octavia II 2004 Workshop Manual page 55

– Connect the plug -3- to the control unit against the
-direction of arrow 3-.
– Push the lever -2- against the -direction of arrow 2-.
– Lock the plug at the control unit, to do so pull the lever -1-
upwards in -direction of arrow 1-. The lever -2- is locked.
Diesel engines with the diesel particle filter:
– Install pre-exhaust pipe with diesel particle filter ⇒ diesel en‐
gine; Rep. gr. 26 .
Continued for all vehicles:
1.9 ltr. diesel engine:
– Install intake manifold flap motor - V157- ⇒ Engine; Rep. gr.
23 (except vehicles with engine identification characters BJB).
– Install connecting hose to inlet connection ⇒ Engine; Rep. gr.
21 .
2.0 ltr. diesel engine:
– Install top toothed belt guard.
– Install connection pipe between intake hose and exhaust tur‐
bocharger.
– Install the bulkhead plenum chamber ⇒ Body Work; Rep. gr.
66 .
– Install battery ⇒ Electrical System; Rep. gr. 27 .
Note
If the battery earth strap is disconnected and connected, carry out
certain additional operations ⇒ Electrical System; Rep. gr. 27 .
– Position engine cover.
– Remove brake pedal load e.g. -V.A.G 1869/2- .
– Bleed brake system
– Code the control unit - J104- ⇒ Vehicle diagnostic tester.
⇒ page 168 .
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not permitted
unless authorised by ŠKODA AUTO A. S. ŠKODA AUTO A. S. does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by ŠKODA AUTO A. S.�
5. Hydraulic Control Unit, Brake Servo Unit/Master Brake Cylinder ABS Mark 70 (ABS/TCS)
Octavia II 2004 ➤ , Octavia II 2010 ➤
Brake systems - Edition 11.2017
49