Summary Of Components - Right-Hand Drive - Skoda Octavia II 2004 Workshop Manual

Octavia II 2004 ➤ , Octavia II 2010 ➤
Brake systems - Edition 11.2017
5.2

Summary of components - right-hand drive

Note
The master brake cylinder and the brake servo unit can be replaced independently of one another.
1 - Screw cap
– Check fitting position
⇒ page 177
2 - Brake fluid reservoir
3 - Sealing grommets
❑ moisten with brake fluid
and press in brake fluid
reservoir
4 - Vacuum hose
❑ positioned in the brake
servo unit
5 - Brake servo
❑ on petrol engines, the
required negative pres‐
sure is drawn from the
intake manifold or it is
generated with a vac‐
uum pump
❑ Vehicles fitted with pet‐
rol engines and auto‐
matic gearbox are
equipped with a brake
vacuum pump - V192-
⇒ page 178 .
❑ vehicles using a diesel
engine are fitted with a
vacuum pump for gen‐
erating a low pressure
⇒ page 178
❑ Inspect proper opera‐
tion:
– With the engine off
press down brake pedal
repeatedly with force
(this reduces the pressure already present in the device).
– Now step on and hold brake pedal with medium pressure and start engine. If the brake servo is functioning
properly, the brake pedal will be felt to go down as the servo takes effect.
❑ if there are faults replace completely
❑ Removing and installing
6 - Gasket
❑ for brake servo
7 - Brake line, 14 Nm
❑ Master brake cylinder/push rod piston circuit THV to hydraulic unit
8 - Master brake cylinder
❑ cannot be repaired
❑ if there are faults replace completely
❑ Removing and installing
176
Rep. gr.47 - Brakes - hydraulics
⇒ page 192
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not permitted
unless authorised by ŠKODA AUTO A. S. ŠKODA AUTO A. S. does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by ŠKODA AUTO A. S.�
⇒ page 186