Removing And Installing Brake Light Switch F And Brake Pedal Switch F47 As Of 11/2005 - Skoda Octavia II 2004 Workshop Manual

The removal and installation of the brake light switch must only
be performed when the tappet is pressed otherwise the locking
mechanism of the brake light switch will be damaged.
The brake light switch must be removed for setting.
Removing:
– Removing driver side trim panel ⇒ Body Work; Rep. gr. 70 .
– Remove air guide -3-.
– Unplug connector -1- from the brake light switch.
– Remove brake light switch -2- by turning 45° to the left.
Installing and setting:
The brake light switch may only be installed once to ensure that
it has an adequately tight fit.
– Pull the tappet out completely before assembly.
– Guide the switch through the assembly opening, press against
the pedal and attach by turning it 45° to the right.
– The brake pedal always remains in the off position in this case
(do not depress!).
– Insert the plug for the brake light switch.
– Inspecting proper operation of the brake light.
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not permitted
unless authorised by ŠKODA AUTO A. S. ŠKODA AUTO A. S. does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by ŠKODA AUTO A. S.�
After setting up the brake light switch, check whether brake pedal
is in the end position (release position).
– Install air guide duct.
– Removing driver side trim panel ⇒ Body Work; Rep. gr. 70 .
4.6 Removing and installing brake light
switch -F- and brake pedal switch -F47-
as of 11/2005
Removing:
– Remove air filter ⇒ Relevant Engine; Rep. gr. 24 or ⇒ Rep.
gr. 21 .
– Remove battery and battery tray ⇒ Electrical System; Rep.
gr. 27 .
Octavia II 2004 ➤ , Octavia II 2010 ➤
Brake systems - Edition 11.2017
4. Brake pedal - left-hand drive
139