Hand Drive - Skoda Octavia II 2004 Workshop Manual

❑ Fitting the control unit to the hydraulic unit
7 - Screw, 2 Nm + 0.8 Nm
❑ Replacing
8 - Rubber bearing
❑ make sure that the rubber bearings are not pressed out of the console when installing the bracket
9 - Console
❑ before installing the rubber bearings
lubricant, e.g. -D 007 000 A2-
10 - Nut, 20 Nm
11 - Screw, 8 Nm
12 - Mounting bracket
❑ Moisten the bolt of the support with lubricant, e.g. -D 007 000 A2- , before inserting into the rubber
bearings
❑ after installing, check for firm seating
13 - Rubber bearing
14 - Screw, 8 Nm
15 - Brake line
❑ to rear left brake caliper
❑ Distinguishing feature: ∅ 5,25 mm and pipe screw with thread M 12 × 1
16 - Brake line
❑ to rear right brake caliper
❑ Distinguishing feature: ∅ 5,25 mm and pipe screw with thread M 10 × 1
17 - ABS hydraulic unit - N55-
❑ Removing and installing
6.8 Connecting the brake lines from the
master brake cylinder to the ABS hy‐
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not permitted
draulic unit - right-hand drive
unless authorised by ŠKODA AUTO A. S. ŠKODA AUTO A. S. does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by ŠKODA AUTO A. S.�
Connect brake lines to the master brake cylinder
A - from master brake cylinder (push rod piston circuit) to ABS
hydraulic unit
- Distinguishing feature: ∅ 6,5 mm and pipe screw with thread M
12 × 1
B - from master brake cylinder (floating piston circuit) to ABS hy‐
draulic unit
- Distinguishing feature: ∅ 6,5 mm and pipe screw with thread M
12 × 1
4 - from the hydraulic unit to the front right brake caliper
⇒ page 80
⇒ Item 8 (page 75)
⇒ page 76
Octavia II 2004 ➤ , Octavia II 2010 ➤
Brake systems - Edition 11.2017
, moisten the holes for rubber bearings with
75